1. Remove any floppy disks from the A drive and try to again.
2. Boot from floppy disk (Windows 95 CD-ROM Setup Boot Disk or MS-DOS 6.xx Disk # 1.
3. Exit setup program and at the DOS prompt type FDISK.
4. Select # 4.

Is there a partition listed?

YES

NO

• The settings should be as follows:

• Exit FDISK and run SYS C:
• Run FDISK/MBR.
• If computer still will not boot, Remove partition and create a new one using FDISK.
  ***All Data Will Be Lost!!***

Return to Troubleshooting

• Create a new partition using FDISK.
• Set the partition as 100% of the drive.
• Set the partition as active.

Return to Troubleshooting